Pro Tip: To prevent repetitive measurements, make a story pole from a scrap piece of wood. Pretty easy. Space the other two stringers evenly apart. You will need to consider how much time you want to spend on upkeep, how much money you have to spend to build the fence, and how long the fence will need to remain in its location. 07 Continue installing the posts. Either way, you’re wasting materials, money and time building a fence that doesn’t suit your yard.

How would a professional handle a 135 degree corner? Or you may find that your 6-ft. tall privacy fence only needed to be 4 ft. tall because surrounding areas slope away from your yard. Re: Best Way To Fasten Rail Between Post? The correct way to build a privacy fence on a hill depends on the severity of the slope. Installing the Stringers. For a shorter fence, two rails could suffice. How to Install Fence Stringers. Extra steps are necessary when installing a 6 foot tall wind-resistant privacy fence as opposed to installing a fence in an area with mild winds. Let’s look at some of the techniques you can use when installing a fence on a slope or a hill. This will prevent splitting. Here's some suggestions on how to install wood stairs. Attach the stringers to the deck using angle brackets and 3” galvanized deck screws. To install a staircase that will be functional, decorative, and safe, certain guidelines must be observed.

When building a fence on uneven terrain, one option is to follow the contours of your yard. There are many different types of materials, all with different benefits and downsides. Here we show you how WE sent fence rails. Step 3: Install the Fencing When installing metal mesh, cut the ends of the mesh at an angle so that the mesh follows the rails while the ends are straight with respect to … Construct the fence properly. In this project, we used a "butt joint" to secure the rail to the body of the post rather than the top of the post. Several common methods exist for attaching fence stringers to posts, including brackets, toenailing and screwing straight through the stringer and into the post. On one side the stringers will be flat against the post and on the other side there'll be a …

The broad flat surface of a closed plank privacy fence bears the full brunt of strong, prevailing winds. Work it to about 2" below the surface to allow for fill dirt later. Fence stringers are the two or three horizontal wooden rails that run between fence posts and that hold the boards or pickets. Several common methods exist for attaching fence stringers to posts, including brackets, toenailing and screwing straight through the stringer and into the post. Typically you’ll need one for each 2 feet of post height. Contoured Fences: Smooth Lines for Gentle Curves Near West Chester, PA: A scalloped partial privacy fence installed on a slope by The Fence Authority. 08 Depending on the fence design, either install stringers and pickets or install the next post(s), whichever is easier. Basically for a 6′ fence, you want a post near the top, bottom, and middle to hold up the fence and keep the pickets straight.