The Aluminum Bar Cap has a nice sliding piece that covers the screws. Polycarbonate extrusions are in a choice of mill, bronze and anodized finishes. At The Polycarbonate Store - We make building easy! You can mount insulated glass units, single sheets of glass from a 1/4″ to 1″ thickness, as well as multi-wall polycarbonate panels on a wood, steel or aluminum sub-structure. Home Polycarbonate Panels. • U-Channel: Use to cap off top and bottom of polycarbonate sheets.

You can cut it with a ten steps. They are available in several shapes including "U" end caps and joining "H" shapes. If this is not the situation, you can consider trimming the length. Pro-seal a durable maintenance free extruded aluminum glazing system. Remember, the length side is the one that follows the extruded ribs.

Joiner cap is also often used to join panels together at your framing.

• H-Channel: Use to join two polycarbonate sheets together. If you are buying polycarbonate sheets from our store, you’ll be able to purchase the sheets at the exact length size of your frame. You can also consider to look at our How to cut the Polycarbonate sheet guide. Aluminum Glazing System components. This can be done with a special breathable tape (B7524), aluminum channel, or by fitting the panel into a Polycarbonate End Cap. Used on any sloped or vertical application. Polycarbonate Fastening System Simplify assembly with these aluminum and polycarbonate profiles and channels. • Helps keep out dirt, insects and moisture. • Allows for a finished, professional look.

Polycarbonate roofing, construction, and building projects are a snap at The Polycarbonate Store, your number one stop for Polycarbonate Glazing.Find polycarbonate sheets in Clear, Opal and Bronze.We also make joining and installing polycarbonate panels a breeze with polycarbonate joiner caps and polycarbonate end caps. installation procedures… When framing with aluminum glazing extrusions, for a glazed sloped roof, all top surfaces of each roof framing member must be on the same plane and flush with each other. Keep in mind that the open ends of the polycarbonate will need Polycarbonate End Cap or Breathable Tape to help keep insects and other problems away.

Aluminum glazing extrusions is the best way to glaze any wood framed structure. The ends of the polycarbonate panels should be enclosed to keep out dust and insects. The aluminum U and H Cap & Base systems shown below are for use with multiwall polycarbonate panels.

Check to make sure that every opening is true and square.